lkml.org 
[lkml]   [2008]   [Mar]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 025/148] include/asm-x86/dma.h: checkpatch cleanups - formatting only
Date

Signed-off-by: Joe Perches <joe@perches.com>
---
include/asm-x86/dma.h | 45 ++++++++++++++++++++++-----------------------
1 files changed, 22 insertions(+), 23 deletions(-)

diff --git a/include/asm-x86/dma.h b/include/asm-x86/dma.h
index e9733ce..ca1098a 100644
--- a/include/asm-x86/dma.h
+++ b/include/asm-x86/dma.h
@@ -12,7 +12,6 @@
#include <asm/io.h> /* need byte IO */
#include <linux/delay.h>

-
#ifdef HAVE_REALLY_SLOW_DMA_CONTROLLER
#define dma_outb outb_p
#else
@@ -74,15 +73,15 @@
#ifdef CONFIG_X86_32

/* The maximum address that we can perform a DMA transfer to on this platform */
-#define MAX_DMA_ADDRESS (PAGE_OFFSET+0x1000000)
+#define MAX_DMA_ADDRESS (PAGE_OFFSET + 0x1000000)

#else

/* 16MB ISA DMA zone */
-#define MAX_DMA_PFN ((16*1024*1024) >> PAGE_SHIFT)
+#define MAX_DMA_PFN ((16 * 1024 * 1024) >> PAGE_SHIFT)

/* 4GB broken PCI/AGP hardware bus master zone */
-#define MAX_DMA32_PFN ((4UL*1024*1024*1024) >> PAGE_SHIFT)
+#define MAX_DMA32_PFN ((4UL * 1024 * 1024 * 1024) >> PAGE_SHIFT)

/* Compat define for old dma zone */
#define MAX_DMA_ADDRESS ((unsigned long)__va(MAX_DMA_PFN << PAGE_SHIFT))
@@ -154,20 +153,20 @@

extern spinlock_t dma_spin_lock;

-static __inline__ unsigned long claim_dma_lock(void)
+static inline unsigned long claim_dma_lock(void)
{
unsigned long flags;
spin_lock_irqsave(&dma_spin_lock, flags);
return flags;
}

-static __inline__ void release_dma_lock(unsigned long flags)
+static inline void release_dma_lock(unsigned long flags)
{
spin_unlock_irqrestore(&dma_spin_lock, flags);
}

/* enable/disable a specific DMA channel */
-static __inline__ void enable_dma(unsigned int dmanr)
+static inline void enable_dma(unsigned int dmanr)
{
if (dmanr <= 3)
dma_outb(dmanr, DMA1_MASK_REG);
@@ -175,7 +174,7 @@ static __inline__ void enable_dma(unsigned int dmanr)
dma_outb(dmanr & 3, DMA2_MASK_REG);
}

-static __inline__ void disable_dma(unsigned int dmanr)
+static inline void disable_dma(unsigned int dmanr)
{
if (dmanr <= 3)
dma_outb(dmanr | 4, DMA1_MASK_REG);
@@ -190,7 +189,7 @@ static __inline__ void disable_dma(unsigned int dmanr)
* --- In order to do that, the DMA routines below should ---
* --- only be used while holding the DMA lock ! ---
*/
-static __inline__ void clear_dma_ff(unsigned int dmanr)
+static inline void clear_dma_ff(unsigned int dmanr)
{
if (dmanr <= 3)
dma_outb(0, DMA1_CLEAR_FF_REG);
@@ -199,7 +198,7 @@ static __inline__ void clear_dma_ff(unsigned int dmanr)
}

/* set mode (above) for a specific DMA channel */
-static __inline__ void set_dma_mode(unsigned int dmanr, char mode)
+static inline void set_dma_mode(unsigned int dmanr, char mode)
{
if (dmanr <= 3)
dma_outb(mode | dmanr, DMA1_MODE_REG);
@@ -212,7 +211,7 @@ static __inline__ void set_dma_mode(unsigned int dmanr, char mode)
* the lower 16 bits of the DMA current address register, but a 64k boundary
* may have been crossed.
*/
-static __inline__ void set_dma_page(unsigned int dmanr, char pagenr)
+static inline void set_dma_page(unsigned int dmanr, char pagenr)
{
switch (dmanr) {
case 0:
@@ -243,15 +242,15 @@ static __inline__ void set_dma_page(unsigned int dmanr, char pagenr)
/* Set transfer address & page bits for specific DMA channel.
* Assumes dma flipflop is clear.
*/
-static __inline__ void set_dma_addr(unsigned int dmanr, unsigned int a)
+static inline void set_dma_addr(unsigned int dmanr, unsigned int a)
{
set_dma_page(dmanr, a>>16);
if (dmanr <= 3) {
dma_outb(a & 0xff, ((dmanr & 3) << 1) + IO_DMA1_BASE);
dma_outb((a >> 8) & 0xff, ((dmanr & 3) << 1) + IO_DMA1_BASE);
} else {
- dma_outb((a >> 1) & 0xff, ((dmanr & 3) << 2) + IO_DMA2_BASE);
- dma_outb((a >> 9) & 0xff, ((dmanr & 3) << 2) + IO_DMA2_BASE);
+ dma_outb((a >> 1) & 0xff, ((dmanr & 3) << 2) + IO_DMA2_BASE);
+ dma_outb((a >> 9) & 0xff, ((dmanr & 3) << 2) + IO_DMA2_BASE);
}
}

@@ -264,18 +263,18 @@ static __inline__ void set_dma_addr(unsigned int dmanr, unsigned int a)
* Assumes dma flip-flop is clear.
* NOTE 2: "count" represents _bytes_ and must be even for channels 5-7.
*/
-static __inline__ void set_dma_count(unsigned int dmanr, unsigned int count)
+static inline void set_dma_count(unsigned int dmanr, unsigned int count)
{
count--;
if (dmanr <= 3) {
- dma_outb(count & 0xff, ((dmanr & 3) << 1) + 1 + IO_DMA1_BASE);
- dma_outb((count >> 8) & 0xff,
- ((dmanr & 3) << 1) + 1 + IO_DMA1_BASE);
+ dma_outb(count & 0xff, ((dmanr & 3) << 1) + 1 + IO_DMA1_BASE);
+ dma_outb((count >> 8) & 0xff,
+ ((dmanr & 3) << 1) + 1 + IO_DMA1_BASE);
} else {
- dma_outb((count >> 1) & 0xff,
- ((dmanr & 3) << 2) + 2 + IO_DMA2_BASE);
- dma_outb((count >> 9) & 0xff,
- ((dmanr & 3) << 2) + 2 + IO_DMA2_BASE);
+ dma_outb((count >> 1) & 0xff,
+ ((dmanr & 3) << 2) + 2 + IO_DMA2_BASE);
+ dma_outb((count >> 9) & 0xff,
+ ((dmanr & 3) << 2) + 2 + IO_DMA2_BASE);
}
}

@@ -288,7 +287,7 @@ static __inline__ void set_dma_count(unsigned int dmanr, unsigned int count)
*
* Assumes DMA flip-flop is clear.
*/
-static __inline__ int get_dma_residue(unsigned int dmanr)
+static inline int get_dma_residue(unsigned int dmanr)
{
unsigned int io_port;
/* using short to get 16-bit wrap around */
--
1.5.4.rc2


\
 
 \ /
  Last update: 2008-03-23 09:41    [W:2.363 / U:0.456 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site