lkml.org 
[lkml]   [2008]   [Jan]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC] PCIE ASPM support
From
Date

On Mon, 2008-01-07 at 10:19 -0800, Kok, Auke wrote:
> Shaohua Li wrote:
> > On Thu, 2008-01-03 at 11:33 -0800, Kok, Auke wrote:
> >> Shaohua Li wrote:
> >>> PCI Express ASPM defines a protocol for PCI Express components in the D0
> >>> state to reduce Link power by placing their Links into a low power state
> >>> and instructing the other end of the Link to do likewise. This
> >>> capability allows hardware-autonomous, dynamic Link power reduction
> >>> beyond what is achievable by software-only controlled power management.
> >>> However, The device should be configured by software appropriately.
> >>> Enabling ASPM will save power, but will introduce device latency.
> >>>
> >>> This patch adds ASPM support in Linux. It introduces a global policy for
> >>> ASPM, a sysfs file /sys/module/pcie_aspm/parameters/policy can control
> >>> it. The interface can be used as a boot option too. Currently we have
> >>> below setting:
> >>> -default, BIOS default setting
> >>> -powersave, highest power saving mode, enable all available ASPM state
> >>> and clock power management
> >>> -performance, highest performance, disable ASPM and clock power
> >>> management
> >>> By default, the 'default' policy is used currently.
> >>>
> >>> In my test, power difference between powersave mode and performance mode
> >>> is about 1.3w in a system with 3 PCIE links.
> >>>
> >>> please review, any comments will be appreciated.
> >>
> >> quickly glanced this over since I recently disabled l1 ASPM for the e1000/e1000e
> >> driven 82573 device which has issues with l1 ASPM. that immediately gives me the
> >> question: how can I continue to disable 1l aspm by default for this device using
> >> this infrastructure?
> > I used to have a per-device interface, but thought the interface might
> > be hard to use for users. If we really need the per-device interface, I
> > can re-add it.
> >
> >> I do like the fact that there is a generic way to re-enable it for the users who
> >> want to use it. Can this change be done when the device is already active?
> > Yes, at least in my test.
> >
> >> Can you
> >> change this parameter per device/module?
> > Another way is to provide a helper for driver, and driver disables
> > specific ASPM states. It sounds better to let driver do the disabling,
> > as users haven't the knowledge?
>
> agreed, however this could still be usefull in debugging equipment for the
> experienced user. In any case an easy handle for the driver to dis/enable ASPM
> would certainly help our case, and possibly others.
Then I'll add a config option, and enable the per-device interface with
config enabled.

Thanks,
Shaohua



\
 
 \ /
  Last update: 2008-01-08 02:51    [W:0.041 / U:1.148 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site