lkml.org 
[lkml]   [2007]   [Jun]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Regression: 2.6.22-rcX: hda: lost interrupt
David Chinner wrote:
> Folks,
>
> After updating an x86_64 machine from 2.6.21 to 2.6.22-rc6 and
> fighting off the where-the-fuck-did-my-serial-console-go blues
> (legacy_serial.force), I finally discovered why the damn thing
> wasn't booting - the machine was sitting there in a loop outputting
> "hda: lost interrupt" over and over again during hardware
> discovery (hda = dvd drive).
>
> It doesn't happen on every boot - more boots hung than failed,
> though, while I was trying to work out where my serial port
> went and get some work done.
>
> Since I've had the console operative, the boot hangs are
> basically like:
>
> ESB2: IDE controller at PCI slot 0000:00:1f.1
> ACPI: PCI Interrupt 0000:00:1f.1[A] -> GSI 20 (level, low) -> IRQ20
> ESB2: chipset revision 9
> ESB2: not 100% native mode: will probe irqs later
> ide0: DM-DMA at 0x50a0-0x50a7, BIOS settings: hda:DMA, hdb:pio
> ide1: DM-DMA at 0x50a8-0x50af, BIOS settings: hda:pio, hdb:pio
> Probing IDE interface ide0...
> hda: probing with STATUS(0xa0) instead of ALTSTATUS(0x58)
> hda: <some ctrl char>, ATAPI UNKNOWN (type 31) drive
> hdb: probing with STATUS(0xb0) instead of ALTSTATUS(0x00)
> hdb: probing with STATUS(0xa1) instead of ALTSTATUS(0x51)
> hdb: <some ctrl char>, ATAPI UNKNOWN (type 31) drive
> hda: set_drive_speed_status: status=0x58 { DriveReady SeekComplete DataRequest }
> hda: set_drive_speed_status: status=0x51 { DriveReady SeekComplete Error }
> hda: set_drive_speed_status: error=0x04 { AbortedCommand }
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> hda: lost interrupt
> hda: lost interrupt
> hda: lost interrupt
> hda: lost interrupt
> hda: lost interrupt
> hda: lost interrupt
> hda: lost interrupt
> hda: lost interrupt
> hda: lost interrupt
> hda: lost interrupt
> hda: lost interrupt

What is the behavior under libata?

If you see timeouts/etc. there too, it might be an interrupt routing or
hardware problem.

Jeff



-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2007-06-29 16:29    [W:1.024 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site