lkml.org 
[lkml]   [2007]   [Nov]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    From
    Subjectb43 on HP nx6325 w/ openSUSE 10.3 (x86_64)
    Date
    Hi,

    I'm trying to make the b43 driver work on an HP nx6325 with openSUSE 10.3
    (64-bit). In short, it sort of works, but some things are a bit ugly.

    The kernel is the current -git (approx. 2.6.24-rc1-git13) with the following
    extra patches applied:

    b43: Fix rfkill callback deadlock
    b43: debugfs SHM read buffer overrun fix
    b43: Rewrite and fix rfkill init

    and I'm using the firmware from
    http://downloads.openwrt.org/sources/broadcom-wl-4.80.53.0.tar.bz2

    Here's the debug info from dmesg:

    b43-phy1: Broadcom 4311 WLAN found
    b43-phy1 debug: Found PHY: Analog 4, Type 2, Revision 8
    b43-phy1 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2
    b43-phy1 debug: Loading firmware version 351.126 (2006-07-29 05:54:02)
    Registered led device: b43-phy1:tx
    Registered led device: b43-phy1:rx
    b43-phy1 debug: Chip initialized
    b43-phy1 debug: 32-bit DMA initialized
    b43-phy1 debug: Wireless interface started
    b43-phy1 debug: Adding Interface type 2

    Now, the first problem is that the card seems to lose frames from time to
    time. This is visible in the output of mtr and while trying to transfer large
    files using scp. With scp the transfer just stalls and stays this way although
    the other end is pingable etc. (eg. attempting to transfer more than 400 MB at
    once triggers this 100% of the time).

    If you can suggest some more specific tests to me, I'll run them and report
    back.

    The second problem is that YaST is apparently unable to detect the device,
    which sort of sucks, because it leads to configuration problems (basically, you
    need to set up everything manually). Evidently, udev manages to handle it, so
    this may be related to HAL. Anyway, it looks like the problem is related to
    the fact that the device is not present under /sys/bus/pci/devices/ directly,
    but you need to go through the ssb0:0 subdirectory to get to it.

    Do you have any ideas how to tell the user space stuff where the devices is
    in sysfs?

    Greetings,
    Rafael
    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.kernel.org
    More majordomo info at http://vger.kernel.org/majordomo-info.html
    Please read the FAQ at http://www.tux.org/lkml/

    \
     
     \ /
      Last update: 2007-11-05 00:59    [W:4.674 / U:0.020 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site