Messages in this thread | | | Date | Thu, 7 Jul 2005 16:53:16 +0300 (EEST) | From | Tero Roponen <> | Subject | Re: 2.6.13-rc2 hangs at boot |
| |
On Thu, 7 Jul 2005, Ivan Kokshaysky wrote:
> On Thu, Jul 07, 2005 at 03:47:58PM +0300, Tero Roponen wrote: > > I just tested the patch, but it didn't help. It still hangs. > > Well, the code in setup-bus.c does actually know about host > bridges, so the patch was just no-op... > > Tero (and others), can you post dmesg from working kernel and, > if possible, from 2.6.13-rc2 captured from serial console? > > Ivan. >
Below is my dmesg from 2.6.12. Unfortunately, I don't have another machine available, so I can't use serial console.
- Tero Roponen
Linux version 2.6.12 (terrop@laptop) (gcc version 4.0.0 20050525 (Red Hat 4.0.0-9)) #2 Sat Jun 18 11:03:55 EEST 2005 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000003fd0000 (usable) BIOS-e820: 0000000003fd0000 - 0000000003fdf000 (ACPI data) BIOS-e820: 0000000003fdf000 - 0000000003fe0000 (ACPI NVS) BIOS-e820: 0000000003fe0000 - 0000000004000000 (reserved) BIOS-e820: 00000000fffe0000 - 0000000100000000 (reserved) 63MB LOWMEM available. On node 0 totalpages: 16336 DMA zone: 4096 pages, LIFO batch:1 Normal zone: 12240 pages, LIFO batch:3 HighMem zone: 0 pages, LIFO batch:1 DMI 2.0 present. Allocating PCI resources starting at 04000000 (gap: 04000000:fbfe0000) Built 1 zonelists Kernel command line: Initializing CPU#0 PID hash table entries: 256 (order: 8, 4096 bytes) Detected 265.384 MHz processor. Using tsc for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 61404k/65344k available (1856k kernel code, 3456k reserved, 683k data, 136k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay loop... 521.21 BogoMIPS (lpj=260608) Mount-cache hash table entries: 512 CPU: After generic identify, caps: 0183f9ff 00000000 00000000 00000000 00000000 00000000 00000000 CPU: After vendor identify, caps: 0183f9ff 00000000 00000000 00000000 00000000 00000000 00000000 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K CPU: After all inits, caps: 0183f9ff 00000000 00000000 00000040 00000000 00000000 00000000 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: Intel Pentium II (Deschutes) stepping 02 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. NET: Registered protocol family 16 PCI: PCI BIOS revision 2.10 entry at 0xfd880, last bus=0 PCI: Using configuration type 1 mtrr: v2.0 (20020519) Linux Plug and Play Support v0.97 (c) Adam Belay PnPBIOS: Scanning system for PnP BIOS support... PnPBIOS: Found PnP BIOS installation structure at 0xc00fe700 PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0xe724, dseg 0xf0000 PnPBIOS: 20 nodes reported by PnP BIOS; 20 recorded by driver PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) Boot video device is 0000:00:03.0 PCI: Using IRQ router PIIX/ICH [8086/7110] at 0000:00:06.0 pnp: 00:0a: ioport range 0x4d0-0x4d1 has been reserved pnp: 00:0a: ioport range 0x15e0-0x15ef has been reserved pnp: 00:0a: ioport range 0xef00-0xefaf could not be reserved IBM machine detected. Enabling interrupts during APM calls. apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16ac) Initializing Cryptographic API Limiting direct PCI/PCI transfers. PCI: Found IRQ 11 for device 0000:00:03.0 PCI: Sharing IRQ 11 with 0000:00:02.0 neofb: mapped io at c4800000 Autodetected internal display Panel is a 800x600 color TFT display neofb: mapped framebuffer at c4a80000 neofb v0.4.2: 2048kB VRAM, using 800x600, 37.878kHz, 60Hz Console: switching to colour frame buffer device 100x37 fb0: MagicGraph 128XD frame buffer device Real Time Clock Driver v1.12 PNP: PS/2 Controller [PNP0303,PNP0f13] at 0x60,0x64 irq 1,12 serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A io scheduler noop registered io scheduler anticipatory registered Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller at PCI slot 0000:00:06.1 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xfcf0-0xfcf7, BIOS settings: hda:DMA, hdb:DMA Probing IDE interface ide0... hda: IBM-DPLA-25120, ATA DISK drive hdb: SANYO CRD-S372B, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... Probing IDE interface ide2... Probing IDE interface ide3... Probing IDE interface ide4... Probing IDE interface ide5... hda: max request size: 128KiB hda: 10009440 sectors (5124 MB) w/468KiB Cache, CHS=10592/15/63, UDMA(33) hda: cache flushes not supported hda: hda1 hda2 hda3 < hda5 hda6 hda7 hda8 hda9 hda10 > hda4 mice: PS/2 mouse device common for all mice input: PC Speaker NET: Registered protocol family 2 IP: routing cache hash table of 512 buckets, 4Kbytes TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) Initializing IPsec netlink socket NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 15 input: AT Translated Set 2 keyboard on isa0060/serio0 ReiserFS: hda6: found reiserfs format "3.6" with standard journal ReiserFS: hda6: using ordered data mode ReiserFS: hda6: journal params: device hda6, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: hda6: checking transaction log (hda6) ReiserFS: hda6: Using r5 hash to sort names VFS: Mounted root (reiserfs filesystem) readonly. Freeing unused kernel memory: 136k freed input: PS/2 Generic Mouse on isa0060/serio1 hdb: ATAPI 24X CD-ROM drive, 256kB Cache, DMA Uniform CD-ROM driver Revision: 3.20 Floppy drive(s): fd0 is 1.44M FDC 0 is a National Semiconductor PC87306 Linux Kernel Card Services options: [pci] [cardbus] [pm] PCI: Found IRQ 11 for device 0000:00:02.0 PCI: Sharing IRQ 11 with 0000:00:03.0 Yenta: CardBus bridge found at 0000:00:02.0 [1014:0092] Yenta: Enabling burst memory read transactions Yenta: Using CSCINT to route CSC interrupts to PCI Yenta: Routing CardBus interrupts to PCI Yenta TI: socket 0000:00:02.0, mfunc 0xfba97543, devctl 0x62 Yenta: ISA IRQ mask 0x0498, PCI irq 11 Socket status: 30000006 PCI: Found IRQ 11 for device 0000:00:02.1 Yenta: CardBus bridge found at 0000:00:02.1 [1014:0092] Yenta: Using CSCINT to route CSC interrupts to PCI Yenta: Routing CardBus interrupts to PCI Yenta TI: socket 0000:00:02.1, mfunc 0xfba97543, devctl 0x62 Yenta: ISA IRQ mask 0x0498, PCI irq 11 Socket status: 30000010 ReiserFS: hda2: found reiserfs format "3.6" with standard journal ReiserFS: hda2: using ordered data mode ReiserFS: hda2: journal params: device hda2, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: hda2: checking transaction log (hda2) ReiserFS: hda2: Using r5 hash to sort names ReiserFS: hda5: found reiserfs format "3.6" with standard journal ReiserFS: hda5: using ordered data mode ReiserFS: hda5: journal params: device hda5, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: hda5: checking transaction log (hda5) ReiserFS: hda5: Using r5 hash to sort names kjournald starting. Commit interval 5 seconds EXT3 FS on hda7, internal journal EXT3-fs: mounted filesystem with ordered data mode. ReiserFS: hda8: found reiserfs format "3.6" with standard journal ReiserFS: hda8: using ordered data mode ReiserFS: hda8: journal params: device hda8, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: hda8: checking transaction log (hda8) ReiserFS: hda8: Using tea hash to sort names kjournald starting. Commit interval 5 seconds EXT3 FS on hda10, internal journal EXT3-fs: mounted filesystem with ordered data mode. cs: IO port probe 0xc00-0xcff: clean. cs: IO port probe 0xc00-0xcff: clean. cs: IO port probe 0x800-0x8ff: clean. cs: IO port probe 0x800-0x8ff: clean. cs: IO port probe 0x100-0x4ff: excluding 0x200-0x207 0x220-0x22f 0x378-0x37f cs: IO port probe 0x100-0x4ff: excluding 0x200-0x207 0x220-0x22f 0x378-0x37f cs: IO port probe 0xa00-0xaff: clean. cs: IO port probe 0xa00-0xaff: clean. cs: memory probe 0xa0000000-0xa0ffffff: clean. eth0: Xircom: port 0x300, irq 3, hwaddr 00:80:C7:72:21:6B Adding 131064k swap on /usr/SWAPFILE. Priority:-1 extents:206 eth0: switching to 10Base2 port eth0: MII selected eth0: media 10Base2, silicon revision 4 eth0: MII selected eth0: media 10Base2, silicon revision 4 eth0: MII selected eth0: media 10Base2, silicon revision 4 atkbd.c: Keyboard on isa0060/serio0 reports too many keys pressed. atkbd.c: Keyboard on isa0060/serio0 reports too many keys pressed. - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |