Messages in this thread | | | Subject | Re: DriveReady SeekComplete Error... | From | Dhruv Matani <> | Date | 15 Jul 2004 09:38:40 +0530 |
| |
On Thu, 2004-07-15 at 01:40, Dwayne Rightler wrote: > demigod:/proc/ide/hda# cat model > SAMSUNG SV2044D
I have: SAMSUNG SV0411N
> > > lspci -vvv output is attached. /dev/hda is attached to the VIA chipset. I > have another hard drive /dev/hdb and a cdrom drive /dev/hdc connected to > that chipset as well and they can do DMA transfers. > > The Promise controller has 2 hard drives hooked to it which can also do DMA > transfers.
I have attached my configuration too. The HDD is connected to the primary master cable, and I have 2 cd-roms (One cd-writer connected to Secondary slave), and the cd-reader connected to the secondary master cable.
> > Thanks, > Dwayne > ----- Original Message ----- > From: "Piszcz, Justin Michael" <justin.piszcz@mitretek.org> > To: "Dwayne Rightler" <drightler@technicalogic.com>; > <linux-kernel@vger.kernel.org> > Cc: "Dhruv Matani" <dhruvbird@gmx.net> > Sent: Tuesday, July 13, 2004 12:23 PM > Subject: RE: DriveReady SeekComplete Error... > > > > Hrmm, does anyone else have that same drive or chipset you use, do they > > also experience the problem? > > > > What is the exact model of the drive and what chipset do you use? > > > > cd /proc/ide/hda ; cat model > > > > lspci -vvv # as root > > > > -----Original Message----- > > From: Dwayne Rightler [mailto:drightler@technicalogic.com] > > Sent: Tuesday, July 13, 2004 11:58 AM > > To: Piszcz, Justin Michael; linux-kernel@vger.kernel.org > > Cc: Dhruv Matani > > Subject: Re: DriveReady SeekComplete Error... > > > > The CONFIG_IDEDISK_MULTI_MODE setting makes no difference as seen below: > > > > demigod:~# uname -a > > Linux demigod 2.6.7-kexec #2 Tue Jul 13 08:31:56 CDT 2004 i686 GNU/Linux > > > > demigod:~# zgrep CONFIG_IDEDISK_MULTI_MODE /proc/config.gz > > CONFIG_IDEDISK_MULTI_MODE=y > > > > demigod:~# dmesg | grep ^hda > > hda: SAMSUNG SV2044D, ATA DISK drive > > hda: max request size: 128KiB > > hda: 39862368 sectors (20409 MB) w/472KiB Cache, CHS=39546/16/63 > > hda: DMA disabled > > hda: dma_timer_expiry: dma status == 0x61 > > hda: DMA timeout error > > hda: dma timeout error: status=0x58 { DriveReady SeekComplete > > DataRequest } > > hda: dma_timer_expiry: dma status == 0x61 > > hda: DMA timeout error > > hda: dma timeout error: status=0x58 { DriveReady SeekComplete > > DataRequest } > > hda: dma_timer_expiry: dma status == 0x61 > > hda: DMA timeout error > > hda: dma timeout error: status=0x58 { DriveReady SeekComplete > > DataRequest } > > hda: DMA disabled > > > > ########################################## > > > > demigod:~# uname -a > > Linux demigod 2.6.7-kexec #1 Mon Jul 5 11:30:36 CDT 2004 i686 GNU/Linux > > > > demigod:~# zgrep CONFIG_IDEDISK_MULTI_MODE /proc/config.gz > > # CONFIG_IDEDISK_MULTI_MODE is not set > > > > demigod:~# dmesg | grep ^hda > > hda: SAMSUNG SV2044D, ATA DISK drive > > hda: max request size: 128KiB > > hda: 39862368 sectors (20409 MB) w/472KiB Cache, CHS=39546/16/63 > > hda: DMA disabled > > hda: dma_timer_expiry: dma status == 0x61 > > hda: DMA timeout error > > hda: dma timeout error: status=0x58 { DriveReady SeekComplete > > DataRequest } > > hda: dma_timer_expiry: dma status == 0x61 > > hda: DMA timeout error > > hda: dma timeout error: status=0x58 { DriveReady SeekComplete > > DataRequest } > > hda: DMA disabled > > hda: dma_timer_expiry: dma status == 0x41 > > hda: DMA timeout error > > hda: dma timeout error: status=0x58 { DriveReady SeekComplete > > DataRequest } > > hda: dma_timer_expiry: dma status == 0x61 > > hda: DMA timeout error > > hda: dma timeout error: status=0x58 { DriveReady SeekComplete > > DataRequest } > > ----- Original Message ----- > > From: "Piszcz, Justin Michael" <justin.piszcz@mitretek.org> > > To: "Dwayne Rightler" <drightler@technicalogic.com>; > > <linux-kernel@vger.kernel.org> > > Cc: "Dhruv Matani" <dhruvbird@gmx.net> > > Sent: Tuesday, July 13, 2004 7:44 AM > > Subject: RE: DriveReady SeekComplete Error... > > > > > > > <*> Include IDE/ATA-2 DISK support > > > [*] Use multi-mode by default > > > > > > Have you tried recompiling the kernel and checking off the second > > option > > > show above? > > > > > > CONFIG_IDEDISK_MULTI_MODE > > > If you get this error, try to say Y here: > > > hda: set_multmode: status=0x51 { DriveReady SeekComplete Error } > > > hda: set_multmode: error=0x04 { DriveStatusError } > > > If in doubt, say N. > > > > > > > > > -----Original Message----- > > > From: linux-kernel-owner@vger.kernel.org > > > [mailto:linux-kernel-owner@vger.kernel.org] On Behalf Of Dwayne > > Rightler > > > Sent: Tuesday, July 13, 2004 8:33 AM > > > To: linux-kernel@vger.kernel.org > > > Cc: Dhruv Matani > > > Subject: Re: DriveReady SeekComplete Error... > > > > > > I have a similar problem with a Samsung hard drive. Model SV2044D. > > The > > > output of 'hdparm -i' below indicates it supports several multiword > > and > > > ultra DMA modes but if i run the drive in anything other than PIO mode > > > it > > > gets DMA timeouts and SeekComplete Errors. This has been on every > > > kernel I > > > can recall in the 2.4 and 2.6 series. > > > > > > demigod:~# hdparm -i /dev/hda > > > > > > /dev/hda: > > > > > > Model=SAMSUNG SV2044D, FwRev=MM200-53, SerialNo=0228J1FN905733 > > > Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs } > > > RawCHS=16383/16/63, TrkSize=34902, SectSize=554, ECCbytes=4 > > > BuffType=DualPortCache, BuffSize=472kB, MaxMultSect=16, MultSect=16 > > > CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=39862368 > > > IORDY=yes, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120} > > > PIO modes: pio0 pio1 pio2 pio3 pio4 > > > DMA modes: mdma0 mdma1 mdma2 > > > UDMA modes: udma0 udma1 udma2 udma3 *udma4 > > > AdvancedPM=no WriteCache=enabled > > > Drive conforms to: ATA/ATAPI-4 T13 1153D revision 17: 1 2 3 4 > > > > > > * signifies the current active mode > > > > > > > > > > > > ----- Original Message ----- > > > From: "Dhruv Matani" <dhruvbird@gmx.net> > > > To: <linux-kernel@vger.kernel.org> > > > Sent: Tuesday, July 13, 2004 7:30 AM > > > Subject: DriveReady SeekComplete Error... > > > > > > > > > > Hi, > > > > I've been getting this error for my brand new (2 months old) Samsung > > > > HDD. The model Number is: SV0411N, and it is a 40GB disk. I'm using > > > the > > > > kernel version 2.4.20-8 provided by RedHat. When I used > > RH-7.2(before > > > > upgrading to RH-9), the same HDD worked fine. Also, when I > > > re-installed > > > > RH-7.2, it worked fine? > > > > > > > > Any suggestions? > > > > > > > > Please cc me the reply, sine I'm not subscribed. > > > > Thanks ;-) > > > > > > > > -- > > > > -Dhruv Matani. > > > > http://www.geocities.com/dhruvbird/ > > > > > > > > As a rule, man is a fool. When it's hot, he wants it cold. > > > > When it's cold he wants it hot. He always wants what is not. > > > > -Anon. > > > > > > > > > > > > - > > > > To unsubscribe from this list: send the line "unsubscribe > > > linux-kernel" in > > > > the body of a message to majordomo@vger.kernel.org > > > > More majordomo info at http://vger.kernel.org/majordomo-info.html > > > > Please read the FAQ at http://www.tux.org/lkml/ > > > > > > > > > > - > > > To unsubscribe from this list: send the line "unsubscribe > > linux-kernel" > > > in > > > the body of a message to majordomo@vger.kernel.org > > > More majordomo info at http://vger.kernel.org/majordomo-info.html > > > Please read the FAQ at http://www.tux.org/lkml/ > > > - > > > To unsubscribe from this list: send the line "unsubscribe > > linux-kernel" in > > > the body of a message to majordomo@vger.kernel.org > > > More majordomo info at http://vger.kernel.org/majordomo-info.html > > > Please read the FAQ at http://www.tux.org/lkml/ > > > > > > > - > > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in > > the body of a message to majordomo@vger.kernel.org > > More majordomo info at http://vger.kernel.org/majordomo-info.html > > Please read the FAQ at http://www.tux.org/lkml/ > > -- -Dhruv Matani. http://www.geocities.com/dhruvbird/
As a rule, man is a fool. When it's hot, he wants it cold. When it's cold he wants it hot. He always wants what is not. -Anon.
[unhandled content-type:application/x-gzip] | |