Messages in this thread | ![/](/images/icornerl.gif) | | From | Thom Borton <> | Subject | Re: PCMCIA CD-ROM does not work | Date | Wed, 15 Oct 2003 09:40:55 +0200 |
| |
Hello Marcelo
The problem starts with 2.4.21-pre1. A couple of seconds after I plug in the PCMCIA card, the system stops. No noise, no oops, just freeze.
Attached you find the corresponding syslog entries.
Thanks a lot, Tobias
On Monday 13 October 2003 14:35, Marcelo Tosatti wrote: > On Sat, 11 Oct 2003, Thom Borton wrote: > > Hey > > > > If have now compiled a series of kernels starting from 2.4.18 up > > to 2.4.22. The drive stops working with 2.4.21. That is indeed > > where the "drivers/ide/legacy" directory was introduced. > > > > What do you mean by binary search? What's a "pre"? > > Try 2.4.21-pre1, 2.4.21-pre2, 2.4.21-pre3 etc. to find exactly > where it stopped working. You can find the patches against 2.4.20 > at > > ftp.kernel.org/pub/linux/kernel/v2.4/testing/old/ > > > Further: In 2.4.22 I get an Oops and the whole system stops when > > I unplug the pcmcia card -> hard reset. > > > > It says: > > > > /////////// > > remove_proc_entry: hde/identify busy, count=1 > > remove_proc_entry: ide2/hde busy, count=1 > > Unable to handle kernel paging request at virtual address > > 655f6373 printing eip: > > c011c5b5 > > *pde = 00000000 > > Oops: 0002 > > CPU: 0 > > ....... > > ....... > > <0>Kernel panic: Aiee, killing interrupt handler! > > In interrupt handler - not syncing > > /////////// > > > > Sound's scarry, but doesnt tell me a lot, except that I have to > > reboot the system. > > Can you please post the full kernel panic message? > > - > To unsubscribe from this list: send the line "unsubscribe > linux-kernel" in the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > Please read the FAQ at http://www.tux.org/lkml/
-- Thom Borton Switzerland Oct 15 09:32:10 grisu kernel: PCI: Found IRQ 9 for device 00:0c.0 Oct 15 09:32:10 grisu kernel: PCI: Sharing IRQ 9 with 00:0a.0 Oct 15 09:32:10 grisu kernel: Yenta IRQ list 00b8, PCI irq9 Oct 15 09:32:10 grisu kernel: Socket status: 30000006 Oct 15 09:32:10 grisu cardmgr[385]: watching 1 socket Oct 15 09:32:10 grisu kernel: cs: IO port probe 0x0c00-0x0cff: clean. Oct 15 09:32:10 grisu kernel: cs: IO port probe 0x0800-0x08ff: clean. Oct 15 09:32:10 grisu kernel: cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x220-0x22f 0x330-0x33f 0x370-0x37f 0x388-0x38f 0x398-0x39f 0x3f8-0x3ff 0x4d0-0x4d7 Oct 15 09:32:10 grisu kernel: cs: IO port probe 0x0a00-0x0aff: clean. Oct 15 09:32:10 grisu cardmgr[386]: starting, version is 3.2.5 Oct 15 09:32:12 grisu anacron[411]: Anacron 2.3 started on 2003-10-15 Oct 15 09:32:12 grisu /usr/sbin/cron[413]: (CRON) INFO (pidfile fd = 3) Oct 15 09:32:12 grisu /usr/sbin/cron[414]: (CRON) STARTUP (fork ok) Oct 15 09:32:13 grisu anacron[411]: Will run job `cron.daily' in 5 min. Oct 15 09:32:13 grisu anacron[411]: Jobs will be executed sequentially Oct 15 09:32:13 grisu /usr/sbin/cron[414]: (CRON) INFO (Running @reboot jobs) Oct 15 09:32:45 grisu cardmgr[386]: socket 0: Ninja ATA Oct 15 09:32:45 grisu kernel: cs: memory probe 0xa0000000-0xa0ffffff: clean. Oct 15 09:32:45 grisu cardmgr[386]: executing: 'modprobe ide-cs' Oct 15 09:32:48 grisu kernel: hde: TOSHIBA CD-ROM XM-7002Bc, ATAPI CD/DVD-ROM drive Oct 15 09:32:48 grisu kernel: ide2 at 0x180-0x187,0x386 on irq 3 Oct 15 09:32:48 grisu kernel: ide_cs: hde: Vcc = 5.0, Vpp = 0.0 Oct 15 09:32:48 grisu cardmgr[386]: executing: './ide start hde' Oct 15 09:32:49 grisu kernel: hde: bad special flag: 0x03
| ![\](/images/icornerr.gif) |