lkml.org 
[lkml]   [2003]   [Oct]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Vortex full-duplex doesn't work?
On Tue, 14 Oct 2003 22:31:09 +0200 Karel Kulhavý <clock@twibright.com> wrote:

| Hello
|
| I have collected from tidbits of information that
| ether=0,0,0x201,0,eth0 should set my 3c900 card to full duplex AUI.
|
| I have tried this, then ifconfig eth0 up and then
| vortex-diag -vv and it still reports MAC Settings: half-duplex
|
| When I rewrite all occurences of full_duplex in 3c59x.c for hard-coded
| "1", then I get MAC Settings: full-duplex
|
| How do I set up this driver to force full-duplex AUI for 3c900 network
| card without using modules and without patching 3c59x.c?

BTW, what kernel version ???

As I indicated in another reply to you, <quote>
Please try this, although I'm not yet convinced that the 3c59x
driver calls all of the right hooks for this to work.
but good luck, and please report back on it. </quote>

It looks to me like (but I haven't traced it completely)
3c59x doesn't call netdev_boot_setup_check() [even indirectly],
and that is needed to set the irq/base/mem_start/mem_end
parameters for use during the probe() function.
(I'm looking at 2.4.22 source code for this.)
(3c59x uses mem_start for driver options flags.)

Can anyone confirm this? If so, we could fix it, but I'd
like to have some confirmation of what I'm thinking on this
since I can't test it (no vortex/boomerang adapter).

--
~Randy
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:49    [W:0.031 / U:0.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site