Messages in this thread | | | Date | Fri, 21 Jul 2000 19:20:53 +0900 | From | Kaoru Fukui <> | Subject | Many collisions(Re: ide problem kernel-2.4.0-Test5 |
| |
Hi!
I'm trying linux-2.4.0-test5 on apple powerpc BWG3v2. I move Linux HD to slow interface then able to boot linux-2.4.0-test5.
I had many collisions.
Any Help?
Kaoru
[unhandled content-type:application/octet-stream]
----------<snip>------------------ Page-cache hash table entries: 131072 (order: 7, 524288 bytes) Inode-cache hash table entries: 32768 (order: 6, 262144 bytes) POSIX conformance testing by UNIFIX PCI: Probing PCI hardware PCI: Address space collision on region 0 of device Texas Instruments PCILynx/ PCILynx2 IEEE 1394 Link Layer Controller PCI: Address space collision on region 1 of device Texas Instruments PCILynx/ PCILynx2 IEEE 1394 Link Layer Controller PCI: Address space collision on region 2 of device Texas Instruments PCILynx/ PCILynx2 IEEE 1394 Link Layer Controller PCI: Address space collision on region 6 of device Texas Instruments PCILynx/ PCILynx2 IEEE 1394 Link Layer Controller PCI: Address space collision on region 0 of device CMD Technology Inc PCI0646 PCI: Address space collision on region 1 of device CMD Technology Inc PCI0646 PCI: Address space collision on region 2 of device CMD Technology Inc PCI0646 PCI: Address space collision on region 3 of device CMD Technology Inc PCI0646 PCI: Address space collision on region 4 of device CMD Technology Inc PCI0646 PCI: Address space collision on region 1 of device Adaptec AHA-2940U2/W PCI: Address space collision on region 6 of device Adaptec AHA-2940U2/W PCI: Address space collision on region 0 of device Apple Computer Inc. Paddington Mac I/O PCI: Address space collision on region 0 of device OPTi Inc. 82C861 usb.c: registered new driver hub
----------<snip>------------------ Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx CMD646: IDE controller on PCI bus 01 dev 08 CMD646: chipset revision 7 CMD646: chipset revision 0x07, UltraDMA Capable CMD646: 100% native mode on irq 26 ide0: BM-DMA at 0x1050-0x1057, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0x1058-0x105f, BIOS settings: hdc:pio, hdd:pio pmac_ide: enabling IDE bus ID 0 hde: MATSHITA CR-589, ATAPI CDROM drive hdf: IBM-DJNA-371350, ATA DISK drive ide2 at 0xd800b000-0xd800b007,0xd800b160 on irq 13 IDE-DMA check ! hdf: 26520480 sectors (13578 MB) w/1966KiB Cache, CHS=26310/16/63 IDE-DMA check ! hde: ATAPI 32X CD-ROM drive, 128kB Cache Uniform CD-ROM driver Revision: 3.11 Partition check: hdf: hdf1 hdf2 hdf3 hdf4 hdf5 hdf6 hdf7 hdf8 hdf9 hdf10 hdf11 PCI: Device 01:04.0 not available because of resource collisions scsi0 : MESH scsi : 1 host. scsi : detected total. Macintosh ADB mouse driver installed. eth0: BMAC+ at 00:50:e4:96:c0:39 ----------<snip>------------------ | |