Messages in this thread | | | Date | Wed, 24 Mar 1999 01:02:29 -0600 (CST) | From | "Andre M. Hedrick" <> | Subject | Re: 2.2.4: Problems writing CDs (ide-scsi emulation, CRW-1622) |
| |
On Tue, 23 Mar 1999, Christoph Lameter wrote:
> Ok. I did what you suggested. Did not work. My log on bootup says: > > VP_IDE: not 100% native mode: will probe irqs later > ide0: BM-DMA at 0x6000-0x6007, BIOS settings: hda:pio, hdb:pio > ide0: VIA Bus-Master (U)DMA Timing Config Success > ide1: BM-DMA at 0x6008-0x600f, BIOS settings: hdc:pio, hdd:pio > ide1: VIA Bus-Master (U)DMA Timing Config Success
You have driver version 0.1
> hda: Maxtor 87000D8, ATA DISK drive > hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x50) > hdb: probing with STATUS(0x00) instead of ALTSTATUS(0x50)
What in the world is going on here? Why is it hunting for a noexistant drive?
> hdc: Memorex CRW-1622, ATAPI CDROM drive > ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > ide1 at 0x170-0x177,0x376 on irq 15 > hda: Maxtor 87000D8, 6679MB w/256kB Cache, CHS=851/255/63 Where did the (U)DMA reporting flag goto??? ^^^^ This is a UDMA drive and tested.
> thus idedma is not enabled on bootup. I enable it later with
This is a problem..........has this always been the case with disks?
> hdparm -m16 -d1 -u1 -c3 -W1 -k1 -K1 /dev/hda > > but do not do anything for /dev/hdc which is on a different controller.
This is good.
> Even if this would be a problem then the ide driver would reset and > disable DMA and thus the next attempt should work. It aint. > > On Tue, 23 Mar 1999, Andre M. Hedrick wrote: > > > Let me guess:: > > Under 2.0.35 you do not have DMA support for your CD-RW, correct? > Correct. Neither under 2.2.4 > > > Now you have DMA support for your CD-RW, correct? > Never tried DMA with CDRW
The kernel does not yet report if you are using (U)DMA with any type/class of ide-cdrom device.
What does hdparm -v /dev/hdc yield?
Andre Hedrick The Linux IDE guy -- http://www.dyer.vanderbilt.edu/server/udma/
APC UPS Daemon Support Center. http://www.brisse.dk/site/apcupsd/ Going FSF/GNU or GPL2 source soon.
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |