Messages in this thread | | | Date | Sun, 21 Mar 1999 11:21:47 -0600 (CST) | From | "Andre M. Hedrick" <> | Subject | Re: UDMA not supported on my board |
| |
On Sun, 21 Mar 1999, Henrik Berglund SdU wrote:
> I tried this ide patch and i think UDMA is working dont know. > P5A-B Moderboard > ALi Aladdin V AGPset > ALi M1543 > > /dev/hda: > Timing buffered disk reads: 64 MB in 5.73 seconds =11.17 MB/sec > > /dev/hda: > Timing buffer-cache reads: 128 MB in 2.13 seconds =60.09 MB/sec
You are cooking with GAS and everything is perfectly set.
> Model=QUANTUM FIREBALL EL5.1A, FwRev=A08.1100, SerialNo=64582625 > Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs } > RawCHS=10602/15/63, TrkSize=32256, SectSize=21298, ECCbytes=4 > BuffType=3(DualPortCache), BuffSize=418kB, MaxMultSect=16, MultSect=off > DblWordIO=no, maxPIO=2(fast), DMA=yes, maxDMA=2(fast) > CurCHS=623/255/63, CurSects=10018890, LBA=yes, LBAsects=10018890 > tDMA={min:120,rec:120}, DMA modes: sword0 sword1 sword2 mword0 mword1 mword2 > IORDY=on/off, tPIO={min:120,w/IORDY:120}, PIO modes: mode3 mode4
You need to get hdparm-3.5 plus patch "f" at the URL below, to get the UDMA reports.
Andre Hedrick The Linux IDE guy -- http://www.dyer.vanderbilt.edu/server/udma/
APC UPS Daemon Support Center. http://www.brisse.dk/site/apcupsd/ Going FSF/GNU or GPL2 source soon.
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |