Messages in this thread | | | Date | Thu, 02 Dec 1999 07:28:21 +0100 | From | Gregoire FAVRE <> | Subject | Re: atyfb and aty128fb faillure 2.3.29 ond x86 and question |
| |
James Simmons wrote:
> Okay. You have the aty128 driver working now right. Have that driver built > into your kernel. Then build your atyfb driver as a module. Then insmod > it. After you insmod you need to run the utility con2fb. I have attached > it to this email for you to compile with the makefile. Since aty128 will > be fb0 then atyfb will be fb1. So you can map say console to fb1 like this > > con2fb 3 1 > > Then switch to this VC. Now if you have one monitor you have to unplug it > and plug it into your regular ATI vidoe card.
Well, I would like but insmod crash my system (I have tried it without the vc option):
atyfb : 3D RAGE PRO (PQFP, PCI) [0x4750 rev 0x7e] 512K RESV, 14.31818 MHz PLL, 100 MHz MCLK BUS_CNTL DAC_CNTL MEM_CNTL EXT_MEM_CNTL CRTC_GEN_CNTL DSP_CONFIG DSP_ON_OFF 860000001 06010080 0081838 00000000 04000000 00000000 00000000 PLL cc cc 24 df f6 04 00 fd 8e 9e 65 05 40 00 00 00 and the screen on it turn on and show me vertical lines of blue, light blue, green and repeat. But the system freeze :-( Have I done something wrong?
Thanks you really much,
Greg ICQ:16624071 ____________________________________________________________________ http://www.unil.ch/ima/docs/Personnes/gfavre
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |