lkml.org 
[lkml]   [2008]   [Aug]   [20]   [last100]   RSS Feed
Views: [more markup]  [less markup]  [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
DateWed, 20 Aug 2008 20:50:37 -0600
From jmerkey@wolfmoun ...
Subject[PATCH 2.6.27-rc4 26/27] mdb: add Kconfig.debug sections and documentation
add Kconfig.debug sections and documentation 

add help sections for MAGIC_SYSRQ keyboard support.


Signed-off-by: Jeffrey Vernon Merkey (jmerkey@wolfmountaingroup.com)

--- a/lib/Kconfig.debug	2008-08-19 14:10:50.000000000 -0600
+++ b/lib/Kconfig.debug	2008-08-19 21:59:34.000000000 -0600
@@ -134,6 +134,43 @@
 	  Say Y here if you are developing drivers or trying to debug and
 	  identify kernel problems.
 
+config MDB
+	tristate "Merkey's Kernel Debugger"
+	depends on DEBUG_KERNEL
+	select MAGIC_SYSRQ
+	select KALLSYMS
+	select KALLSYMS_ALL
+	default m
+	help
+           Kernel Debugger for Linux written by Jeffrey Vernon
+           Merkey.  'echo j > /proc/sysrq-trigger' will activate the
+           debugger from the text based Linux Console, and the 'j'
+           character (alt-printscreen/sysrq + 'j') with MAGIC_SYSRQ
+           enabled to enter the debugger.  X is not supported.
+           This debugger is minimal and text based.  Excellent help can
+           be obtained from the debugger by typing "Help Help" or
+           "help" from the debugger command console.  If you compiled
+           MDB as a module you may need to load the debugger with
+           the 'modprobe mdb' before you can access the debugger
+           from the Linux Console.  To enable the MAGIC-SYSRQ key
+           type 'echo 1 > /proc/sys/kernel/sysrq'.
+
+config MDB_CONSOLE_REDIRECTION
+	bool "MDB Console Redirection Support"
+	depends on MDB
+	default y
+	help
+           Reset any Console Redirection to default system settings (0)
+           when the MDB debugger is active.  The Debugger will restore
+           the redirection to the custom settings when the debugger
+           is exited.  This feature is useful on systems which by default
+           redirect printk output and the screen debugger output to a log
+           file or system device, which can prevent the debugger screen from
+           being visible.  Enabling this feature does not affect or disable
+           remote operations via serial port.  It is recommended to enable
+           this feature by default if intensive debugging is intended for
+           the target system.
+
 config DEBUG_SHIRQ
 	bool "Debug shared IRQ handlers"
 	depends on DEBUG_KERNEL && GENERIC_HARDIRQS

\
 
 \ /
  Last update: 2008-08-21 05:27    [from the cache]
©2003-2008