lkml.org 
[lkml]   [2008]   [Jun]   [14]   [last100]   RSS Feed
Views: [more markup]  [less markup]  [headers]  [forward] 
 
Messages in this thread
/
DateSat, 14 Jun 2008 10:29:00 +0100
FromAlan Cox <>
SubjectRe: 2.6.25.3: serial problem (minicom)
>    Setting the baud rate to B0 clears both (as per SUS).
> 
>    Subsequently setting the baud rate to something other than B0 leaves the
>    control lines low.
> 
> As it happens, apart from the fact that it breaks minicom, I actually prefer 
> this behavior.

What happens after you go from B0->Banythingelse should depend on the
termios settings at that point. This sounds like a bug therefore.

If you want that behaviour intentionally set B0, after this termios
call then set CLOCAL before changing the baud back.

I'll take a look at this next week.

Alan


\
 
 \ /
  Last update: 2008-06-14 11:49    [from the cache]
©2003-2008