lkml.org 
[lkml]   [2024]   [Feb]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Date
Subject[PATCH 23/23] MIPS: mobileye: eyeq5: map GPIOs to pins using gpio-ranges
Create a mapping between the GPIO controllers and the pin controllers.
GPIO is handled in a one-instance-per-bank manner while pinctrl is done
with a single instance for both pin banks.

See gpio-ranges documentation:
Documentation/devicetree/bindings/gpio/gpio.txt

Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
---
arch/mips/boot/dts/mobileye/eyeq5.dtsi | 2 ++
1 file changed, 2 insertions(+)

diff --git a/arch/mips/boot/dts/mobileye/eyeq5.dtsi b/arch/mips/boot/dts/mobileye/eyeq5.dtsi
index 5f00d129c057..68f6c81331d7 100644
--- a/arch/mips/boot/dts/mobileye/eyeq5.dtsi
+++ b/arch/mips/boot/dts/mobileye/eyeq5.dtsi
@@ -168,6 +168,7 @@ gpio0: gpio@1400000 {
interrupts = <GIC_SHARED 14 IRQ_TYPE_LEVEL_HIGH>;
gpio-controller;
#gpio-cells = <2>;
+ gpio-ranges = <&pinctrl 0 0 29>;
interrupt-controller;
#interrupt-cells = <2>;
resets = <&reset 0 26>;
@@ -182,6 +183,7 @@ gpio1: gpio@1500000 {
interrupts = <GIC_SHARED 14 IRQ_TYPE_LEVEL_HIGH>;
gpio-controller;
#gpio-cells = <2>;
+ gpio-ranges = <&pinctrl 0 29 23>;
interrupt-controller;
#interrupt-cells = <2>;
resets = <&reset 0 26>;
--
2.43.1


\
 
 \ /
  Last update: 2024-05-27 15:02    [W:1.835 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site