lkml.org 
[lkml]   [2011]   [May]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Subject[PATCH 09/16] cciss: clarify messages around reset behavior
From
Date
From: Stephen M. Cameron <scameron@beardog.cce.hp.com>

When waiting for the board to become "not ready"
don't print a message saying "waiting for board to
become ready" (possibly followed by a message saying
"failed waiting for board to become not ready". Instead,
it should be "waiting for board to reset" and "failed
waiting for board to reset."

Signed-off-by: Stephen M. Cameron <scameron@beardog.cce.hp.com>
"
---
drivers/block/cciss.c | 5 +++--
1 files changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/block/cciss.c b/drivers/block/cciss.c
index 1a4dff0..3b55723 100644
--- a/drivers/block/cciss.c
+++ b/drivers/block/cciss.c
@@ -4586,11 +4586,11 @@ static __devinit int cciss_kdump_hard_reset_controller(struct pci_dev *pdev)
msleep(CCISS_POST_RESET_PAUSE_MSECS);

/* Wait for board to become not ready, then ready. */
- dev_info(&pdev->dev, "Waiting for board to become ready.\n");
+ dev_info(&pdev->dev, "Waiting for board to reset.\n");
rc = cciss_wait_for_board_state(pdev, vaddr, BOARD_NOT_READY);
if (rc) /* Don't bail, might be E500, etc. which can't be reset */
dev_warn(&pdev->dev,
- "failed waiting for board to become not ready\n");
+ "failed waiting for board to reset\n");
rc = cciss_wait_for_board_state(pdev, vaddr, BOARD_READY);
if (rc) {
dev_warn(&pdev->dev,
@@ -4641,6 +4641,7 @@ static __devinit int cciss_init_reset_devices(struct pci_dev *pdev)
return -ENODEV;

/* Now try to get the controller to respond to a no-op */
+ dev_warn(&pdev->dev, "Waiting for controller to respond to no-op\n");
for (i = 0; i < CCISS_POST_RESET_NOOP_RETRIES; i++) {
if (cciss_noop(pdev) == 0)
break;


\
 
 \ /
  Last update: 2011-05-03 22:03    [W:0.080 / U:0.420 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site